• Added information that Dry 2 contacts are reserved and unused at this time.
• Updated smart load and AC coupling configuration information in sections 7 and 9.
• Added off-grid configuration example in section 6.1.
• Updated Monitor Center main page image to reflect the Monitor Center update.
• Added idle consumption and transfer time data.
• Corrected link for the QR code on the front page.
• Added ground and neutral torque settings.
• Updated minimum FW for inverters when connected to GridBOSS
• Updated GridBOSS enable settings and image in section 6.6
• Added torque wrench to the recommended tools list
10-31-24 - Published v1.1.2
• Modified spec sheet FCC Part 15, Class B to read as (pending)
• Modified formatting throughout the document
• Added suggestion for users to follow UL514B when installing the unit in section 6.1
• Added breaker sizes included in the shipment to section 6.4
• Added table describing breaker use cases to section 6.4
• Added nominal knockout sizing table to section 6.4
• Added additional spacing information in section 6.1
• Added additional component compatibility for smart ports 3/4 in section 4.4
• Modified section numbering
10-16-24 - Published v1.1.1
• Updated specifications table to include hybrid breaker sizes and unsupported inverter note.
• Added breaker installation section.
10-15-24 – Published v1.1.0
• Initial document release
To Next Page
Loading...
