6.2 RECOMMENDED TOOLS
6.3 MOUNT THE UNIT
1. Select a suitable location to install the GridBOSS as
described in section 6.1.
2. Use the wall mounting bracket as a template to mark
where the screws will be installed. When installing the
wall bracket to studs, verify that the marks for the screws
are centered over a stud.
Phillips & Flat Head
Screwdrivers
SAE & Metric Hex
Wrench Sets
Safety Glasses Dielectric Shoes
Gloves
Protective Mask
Multimeter
Utility K
nife
Wire Cutter Wire Stripper Marking Pen or Pencil
Tape Measure
Hammer
Socket Set
Electric Drill &
Masonry Bit
To Next Page
Loading...
