To Next Page

To Previous Page

• Discharge Cut-off SOC(%): Set this according to the battery requirements. Range is 0-90

• On Grid EOD Voltage(V): The inverter will stop discharging the battery at this Voltage and

will use AC to power loads.

• On Grid EOD SOC(%): The inverter will stop discharging the battery at this SOC and will

use AC to power loads.

6.5 OTHER SETTING

• Batt Volt Sample Disable: Set to Internal, External or Both Available.

• Fan 1 Max Speed(%): This sets cooling fan 1 max. speed. Range is 50-100%.

• Fan 2 Max Speed(%): This sets cooling fan 2 max. speed. Range is 50-100%.

6.6 RESET

• All to Default: This resets all settings to factory default values.

NOTE: Be sure to keep track of your settings and what changes need to be made before powering

the system back on!

Questions and Answers:

Need help?

Do you have a question about the EG4 LuxPowerTek 6000XP and is the answer not in the manual?

EG4 LuxPowerTek 6000XP Specifications

General

Category	Inverter
Rated Power	6000W
Max DC Input Power	7800W
Number of MPPT Trackers	2
Battery Voltage	48V
Max Charge/Discharge Current	120A
Protection Degree	IP65
Frequency	50/60Hz
Model	LuxPowerTek 6000XP
Communication	RS485
Operating Temperature Range	-25°C to 60°C
Protection Features	Over Voltage Protection, Over Temperature Protection
Cooling	Fan