23
USER MANUAL INFUSOVET CONNECT INFUSION PUMP
T +49 7461 96 580 0 | F +49 7461 96 580 90 | export@eickemeyer.com | www.eickemeyer.com
6. BASIC OPERATION
6.1 Operation Flow
1. Power on
2. Install IV Set
3. Select infusion tube brand or add new brand
4. Select infusion mode
5. Set Infusion Parameters
6. Remove air bubble from the line
7. Connect the infusion line with the animal
8. Start infusion
9. Infusion fi nish
10. Remove the IV Set
11. Power off or Standby
6.2 Infusion Operation
6.2.1 Starting and Self Test
1. Press , power on the equipment.
2. After power on, the system will automatically check the motor, sensor, battery, memorizer, CPU communication, alarm
indicator.
3. After the self-test is successful, the prompt interface: “New treatment” and “Last treatment”.
Select “New Treatment” to go directly to the ml/h mode setting interface.
Select “Last treatment” to enter the last usage mode parameter setting interface.
Warning!
If the self-test item does not pass, please contact EICKEMEYER® and you are not allowed to continue using the
equipment.
To Next Page
Loading...
Need help?
General
