Technical Support - MDM 31/97 599 76 11-68 Rev. 01
- Reading/Deleting the last alarm
- The LEDs, groups of symbols
in the LCD screen and the
backlight of the display are
turned on in sequence
- Touch a sensor to turn on
the group of icons in the LCD
screen or the corresponding
LED and the buzzer sounds
at the same time
User interface
functioning
(*) In most cases, this time is sufficient to check the heating. However, the time can be increased by repeating the phase without draining the
water: pass for a moment to a different phase of the diagnostic cycle and then back to the heating control phase (if the temperature is higher
than 80C, heating does not take place).
(**) The check at the maximum speed occurs without control of the A.G.S. and no garments must be inside the appliance.
To Next Page
Loading...
