Commissioning the system
1. (See A) Locate the Ethernet port on the ELKO SmartHUB.
2. Connect an Ethernet cable between the Hub and the router to suit the
installation method used for the hub:
• (See B) Wall box installation
• (See C) Wall mount using two screws
• (See D) Table mount using optional Docking Kit
Post-requisite: You must add the hub to the app before you can add devices to
control them. To do this, first download and install the app on your mobile phone
(see ) and register a user account. You can then add the hub and optionally
connect the hub to the network router by Wi-Fi.
AP mode connection (Wi-Fi)
NOTE: The AP mode is supported in the smartHub . The date code must be
2035 and above when it is moved from out of the box. To update the latest
firmware, connect the hub to the Ethernet (see Ethernet mode connection-
Smart Hub, page 19).
1. Download the app to your mobile phone. See Downloading the ELKO Smart
app, page 21 .
2. Register an account to use the app. See Creating an ELKO Smart app
account, page 21 .
3. Commission the hub using AP mode. See .
20 SUG_ELKO_Norway_04
To Next Page
Loading...
Need help?
General