EasyManuals Logo

Elko Smart User Manual

Elko Smart
66 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #47 background imageLoading...
Page #47 background image
Pairing to other devices
Creating a Room Control network and adding devices
Creating a Room Control group
Create Room Control groups by assigning one or more devices as Receivers and
Senders.
Important information for puck devices:
WARNING
DANGER DUE TO ELECTRIC SHOCK
Observe the regulations for working on live parts.
Only actuate the device buttons using insulated auxiliary equipment that
meets the requirements of EN 60900.
Failure to follow these instructions can result in death, serious injury, or
equipment damage.
Multiple Room Control groups can be created. A device can be a Receiver in one
or more groups and can also be a Sender in another group. However, only one
Sender can be configured each time this task is performed. Repeat this task to
configure more Sender/Receiver combinations.
IMPORTANT: Do not mix lighting and shutter control devices in the same
group.
1. Open the network. Short-press the button on one of the devices 8 times. The
LEDs on all devices in the network display solid green.
SUG_ELKO_Norway_04 47

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Elko Smart and is the answer not in the manual?

Elko Smart Specifications

General IconGeneral
BrandElko
ModelSmart
CategoryHome Automation
LanguageEnglish