Pairing to other devices
2. Select each device that you want to control (Receiver). Short-press each
Receiver device button 3 times. While the Zigbee network is open in Room
Control:
– connected lighting load blinks On/Off.
– connected shutter moves slightly up/down or its slats briefly open/close
(based on your selection for the shutter control setting).
TIP: You can de-select a device by again short-pressing the device button
3 times, followed by one long-press.
3. Select the device to use as the controller (Sender). Short-press the
Sender device button once. The group is created and the network is closed.
NOTE: The SmartRelay puck 10AX, SmartDim puck uni and SmartBlinds
puck cannot be set as the Sender.
IMPORTANT: Be aware of the differences when selecting push buttons:
• The Puck devices cannot be set as the Sender.
Assigning Receivers (R) and a Sender (S)
Removing a Room Control group
Remove the link between Sender devices and related Receiver devices when the
Room Control group is no longer needed.
IMPORTANT: Only perform this task where there is no hub network.
1. On the Sender device, short-press the device button 3 times then press and
hold the button for 6 seconds. (Refer to the device user manual-see links to
the user manuals in Supported devices, page 10.)
48 SUG_ELKO_Norway_04
To Next Page
Loading...
Need help?
General