Commissioning the system
4. (See C) Tap the Wi-Fi tab, set the SSID and Password for the Wi-Fi network
router and then tap Apply.
Settings
Ethernet
SSID
Password
DHCP
Enable
Wi-Fi
Apply
Enter Password
jio_wiser
C
5. Once the Wi-Fi connection is successful, remove the Ethernet cable from the
hub.
Commissioning devices
Add ELKO Smart devices to a Home, assign each device to a Room and configure
device settings.
Adding a device to the Home
Add an ELKO Smart device to a Home using the ELKO Smart app.
NOTE:
• An ELKO SmartHUB must be commissioned and operating before adding
a device.
• Add mains-powered devices before battery-powered devices. (Mains-
powered devices act as routers for battery-powered devices.)
• Devices that connect to the network router such as, IP camera, do not
require the hub to be commissioned before add the device.
1. Log in to the app.
2. (See A) Select the Home to which the ELKO Smart device will be added.
SUG_ELKO_Norway_04 29
To Next Page
Loading...
Need help?
General