Pairing to other devices
3. (See C, D) Short press the push button (C) or (D) that you want to control the
devices. For creating bindings between Switches and other device, you must
push the up button.
This creates a pairing between the Wireless Switch and the compatible
devices.
Once the pairing is successful, the Room Control network closes. The status
LED in all devices turns off.
TIP: The Room Control network remains open if the pairing is
unsuccessful.
Removing a Wireless Switch from a Room Control group
Remove the link between Wireless Switch and other devices when the remote
control operation is no longer needed.
1. (See A, B) Short press the push button (A) 3 times then press and hold the
button for 6 seconds.
The status LED (B) blinks green after 6 seconds.
NOTE: The pairing between the Wireless Switch and compatible devices
is removed.
Set-up of local scenes with Wireless Switch
A scene can set-up to 16 devices to the required status by pressing one of the
rockers. In a scene, both shutter and lighting devices can be combined, and the
scenes can be controlled without internet access.
NOTE: Scenes are not the same as moments in the app - that can also set the
temperature, change device settings, control the camera and activate or
deactivate automations.
SUG_ELKO_Norway_04 51