Pairing to other devices
2. Release the device button when the device LED blinks green at 6 s.
NOTE: All bindings between the Sender and Receivers are removed.
Adding a Wireless Switch to a Room Control network
Before using the Wireless Switch as a remote controller, it must first be added to a
Room Control network.
To perform adding Wireless Switch , the target Room Control Network should be
OPEN state first. In a Room Control network the Wireless Switch works as a
Sender but not as a Receiver.
NOTE: When the wireless switch is paired to an ELKO SmartHUB, it is
automatically set to 2-channel mode. Further setup of the device is done in the
ELKO Smart App.
1. Remove the rocker (A) from the Wireless Switch to see the status LED.
2. (See B, C) Short press the push button (B) 3 times.
The status LED (C) blinks amber and then turns green upon successful
connection to the Room Control network.
TIP: To save the battery, the green LED in the Wireless Switch turns off
after a few seconds, but the Wireless Switch remains in Room Control
network.
Pairing compatible devices to the Wireless Switch
Before using the Wireless Switch as a remote controller, it must first be added to
an existing network. See Adding a Wireless Switch to a Room Control network,
page 49.
SUG_ELKO_Norway_04 49
To Next Page
Loading...
Need help?
General