Commissioning the system
2. (See C, D) Tap the Home to add members to (C) and then tap Add Member
(D).
Home Management
Test Home
New Home
Add Home
Join a Home
C
Home Settings
Home Name
Add Member
New Home
Room Management
16 Room(s)
Home Members
Me
me@emailaddr.com
Home Location
Transfer Home Ownership
The Invitation Code is inactive
Home Owner
Delete Home
D
3. (See E) Choose from any of the options displayed to send the invitation link
to the Home members to be added in the Home.
Home Settings
Home Name
Add Member
New Home
Room Management
16 Room(s)
Home Members
Me
me@emailaddr.com
Home Location
Transfer Home Ownership
The Invitation Code is inactive
Home Owner
Delete Home
The Invitation Code is inactive
Cancel
Share
App account Messages Copy More
E
Commissioning the Hub (Ethernet mode)
If the hub is connected to the network by Ethernet, commissioning involves adding
the hub to the Home using the app.
Before commissioning the hub, the hub must be connected to the Wi-Fi network
router using an Ethernet cable. (See Connecting the hub to the Wi-Fi network,
page 19 .) After commissioning, you can optionally switch the connection to Wi-Fi,
if needed. (See Switching the Hub Ethernet connection to Wi-Fi (optional), page
28.)
NOTE: Before commissioning the hub, make sure that both the hub and
mobile phone are connected to the same Wi-Fi network router.
Commissioning the hub (AP mode)
AP mode is used to commission the hub via wireless rather than Ethernet. There
might be situation when it is not much convenient to use Ethernet mode for
commissioning the hub , the installer can choose AP mode.
Pre-requisite:
• The AP mode is supported in the smartHub. The date code must be 2035 and
above when it is moved from out of the box. To update the latest firmware,
connect the hub to the Ethernet (see Ethernet mode connection- Smart Hub,
page 19).
24 SUG_ELKO_Norway_04
To Next Page
Loading...
Need help?
General