Device LED behavior
Device LED behavior
Devices have LEDs to indicate their operating status and to confirm actions such
as resetting or joining a network.
SmartHUB
Status LED Indication LED Indication Duration
Switching On/Restarting All 3 LEDs display solid white 40 s
Connected to router (Wi-Fi) WLAN LED displays solid white While connected to router
Connected to router (Ethernet) Ethernet LED displays solid white While connected to router
Zigbee network initialized Zigbee network LED displays solid white While Zigbee network is available
Zigbee network open for pairing (Wi-Fi) WLAN LED displays solid white, Zigbee
network LED blinks white
While Zigbee network is open
Zigbee network open for pairing (Ethernet) Ethernet LED displays solid white, Zigbee
network LED blinks white
While Zigbee network is open
Resetting SmartHUB
Reset Level User Action LED Indication LED Indication Duration
Level 1 reset in progress.
(Restores Ethernet/WLAN
settings only)
Press and hold the Reset button
for 5 to 15 seconds
Ethernet/WLAN LEDs blink
white.
LEDs blink once.
Level 2 reset in progress. (Upon
successful reset, all
configuration data, user data,
and network data is deleted).
Press and hold the Reset button
for more than 15 seconds
Ethernet/WLAN LEDs blink
white.
LEDs blink 3 times.
Pairing
Device User Action LED Indication Status
Sensors, Pucks, Dimmers,
Switches, SmartPlug, Shutter
control, Wireless switch
Press the push button 3 times LED blinks orange, once per
second.
Pairing mode is active for 30
seconds. When pairing is
completed, LED displays solid
green for a time, before turning
Off.
IP camera Indoor Plug-in the power cable to
power on the device
After a few seconds LED starts
blinking red for pairing.
LED glows green, when the
pairing mode is complete.
52 SUG_ELKO_Norway_04
To Next Page
Loading...
Need help?
General