Device LED behavior
Power indication
Device User Action LED Indication Status
SmartPlug No action LED displays solid red. SmartPlug power is On.
Resetting smart devices
Device User Action LED Indication Status
Sensors, Pucks, Dimmers,
Switches, SmartPlug, Shutter
control, Wireless switch
Press the push button 3 times
and hold it down once for > 10 s.
After 10 s, the LED starts
blinking red.
The device is in reset mode. It is
reset to the factory settings after
10 seconds. The device then
restarts and the LED starts
blinks green, before turning Off.
Connected sockets
Status
LED Indication Description
Setting 1 (Default state) The Red LED glows. • The Red LED glows when the output
is switched ON
• The LEDs are OFF, when the output
is OFF.
All the LEDs are OFF.
Setting 2 The Red LED glows • Red LED is ON when output is ON.
• Green LED is ON when output is OFF.
The Green LED glows
Setting 3 All LEDs are OFF • All LEDs are OFF, when the output is
OFF.
• Green LED is ON when output is OFF.
Green LED is glows
Setting 4 All LEDs are OFF There will be no LED indication in any case
of the output state.
NOTE: Above settings are done in the app.
Smart Radiator Thermostat
Normal use
State User action Left LED Centre LED Right LED Duration
Boost up Twist the cap in the
+ direction
Not active Not active Solid for 5 seconds.
Boost down Twist the cap in the
— direction
Not active Not active
Solid for 5 seconds.
SUG_ELKO_Norway_04 53
To Next Page
Loading...