Elko Smart User Manual

Device LED behavior
Head calibration
State User action Left LED Centre LED Right LED Duration
Start up Insert the batteries
Single quick flash
Opening the valve Automatic upon
inserting batteries
OR Twist and hold
the cap in +
direction
Not active Not active Solid until the valve
is open
Ready to install on
the valve
The radiator
thermostat is ready
to install when the
valve is fully open
Red and Blue: Flash
for up to 5 minutes
Orange solid= not
joined | Green solid=
joined
Closing the valve Twist and hold the
cap in the —
direction for 2
seconds
Not active Not active
Solid until the valve
is closed
Joining Twist and hold the
cap in the +
direction for 3
seconds
Not active
Not active Pulses for up to 2
minutes
Join success Not active Not active Solid for 5 seconds
Failed to join If no network is
found after 2
minutes
Not active
Not active Flashes for 5
seconds
Error state
State User action Left LED Centre LED Right LED Duration
Low battery Twist the cap in the
+ direction
Not active Not active Solid for 1 second
(Repeated each
hour)
Critical battery Twist the cap in the
— direction
Not active
Not active Fast flash for 5
seconds (Repeated
each minute)
No signal Twist the cap in the
+ direction to start a
boost
Not active Not active Fast flash for 5
seconds (Repeated)
No signal Twist the cap in the
— direction to start a
boost
Not active Not active
Fast flash for 5
seconds (Repeated)
No network Twist the cap in the
+ or — direction to
start a boost
Not active Not active Solid with fade-out
after 2 seconds. In
this event, the
radiator thermostat
has not joined the
system and must
either join the hub or
re-installed.
Smoke Alarm Battery
Pairing
User Action LED Indication Status
Press the Setup/Reset button 3 times LED blinks yellow, once per second.
Pairing mode is active for 30 seconds.
When pairing is completed, LED glows
green for some time before turning Off.
54 SUG_ELKO_Norway_04

Elko Smart Specifications

General

Brand	Elko
Model	Smart
Category	Home Automation
Language	English