7
BEFORE YOU USE
■ The supplied power cord and AC adapter are designed for exclusive use with this
product. Do not use them with other equipments.
■ Be sure to use the power cord applicable to your local power specifications. If the
product was sold in Japan, use the AC adapter sold with the product with 100VAC
and 50 or 60 Hz.
■ Do not knot or coil the power cord or AC adapter cord or wrap them around the AC
adapter. Doing so may damage the cords, causing fire or electric shock.
■ When storing the product, do not leave it under direct sunlight or by heaters. It may
be discolored, deformed, or damaged.
■ Do not place this product in any humid, dusty, salt bearing wind, or vibrating
locations.
Use it under the following environmental conditions:
Temperature: 0°C - 40°C (32°F - 104°F)
Humidity: 30% - 85% (No condensation)
■ Use a soft, dry cloth for cleaning.
Do not use any volatile solvent such as thinner or benzene.
■ Do not point the camera lens directly at the sun. It may be damaged and you may not
be able to take pictures
■ Luminescent and Black Spots
■ There may be some pixels that do not properly operate due to the use of CMOS Area
Image Sensors made-up of many pixels. Though luminescent or black spots may be
found on the screen, it is a phenomenon peculiar to the CMOS Area Image Sensors
and is not a malfunction.
■ Follow the guidelines below to prevent the unit from dropping or overturning.
• Use the product on a stable base, desk, or table. Do not place the product on an
unstable base or slanted location.
• Place or wire the unit to prevent the AC adapter cord or video cable from pulling.
■ Carry the product by holding the lower part of the main unit in both hands. Never
hold the product by the arm or the camera head.
■ Pay careful attention when using (including setting-up and storing) or transferring
the product to prevent the camera head from receiving any shocks.
■ Do not look directly into the LED light. If you look directly into it at point-blank range,
your eyes may be injured.