• If the displayed image is off-center, adjustment of the horizontal and vertical position should be made
from a connected device.
• In some cases, vertical stripes may appear on the display device. This can be reduced by adjusting
the “clock phase” function of a connected device.
• We recommend using the supplied USB cable or commercially available USB 2.0 compliant USB
cable.
• If you connect the USB cable while the TX-1 or a computer is turned on, a computer may not
recognize the device.
• Depending on the computer’s USB environment or the peripheral equipment, image transfer may be
disrupted.
• Successful operation in all environments and conditions is not guaranteed.
② To connect to a computer via the USB cable
Connect the supplied USB cable to the USB terminal on the rear panel.
③ To connect to a device with an HDMI input terminal
Connect a commercially available HDMI cable to the HDMI OUT terminal on the rear panel.
④ To connect to a device with an analog RGB terminal
Connect the RGB cable to the RGB OUT terminal on the rear panel.
⑤ To use the Anti theft lock hole
Connect a security cable to this hole to prevent theft.
・Use a monitor which supports input resolution of 720p or higher.
The TX-1 may not operate with the cable which does not conform to the HDMI standard.
・The TX-1 conforms to the HDMI standard. However, we do not guarantee the operation of all
types of monitors with the TX-1.
Caution
Use the supplied USB cable (gray) to connect the TX-1 to a computer.
To Next Page
Loading...
