33
3-3 CONNECTING VIA WiFi
This section explains how to connect the TX-1 to a computer via WiFi.
①Connecting the TX-1 directly to a computer via WiFi using the Access Point mode
②Connecting the TX-1 to a computer through the ICB or third party’s wireless system using
the Station mode
①Connecting the TX-1 directly to a computer via WiFi using the Access Point mode
1．Open the WiFi settings of your computer and select the SSID of the TX-1.
（The SSID/key of the TX-1 is in the Information of the Menu. The SSID/key is in the
bottom of the TX-1. For details about the WiFi settings of your computer, refer to the
instruction manual of your computer. ）
2．Enter the Key and connect to your computer wirelessly.
3．The WiFi LED starts to flash blue and then turns blue.
※The [AP mode] icon will be displayed on the screen.
4．By connecting to a computer with “Image Mate 4 (TX-1 control software)” installed, you
can control the TX-1 from Image Mate 4.
※Only one computer can be wirelessly connected to the TX-1 at a time.
②Connecting the TX-1 to a computer through the ICB or third party’s wireless system using
the Station mode
1．Change the WiFi mode of the TX-1 to the Station mode.
［ MENU ］＞［ Settings ］＞［ Network mode］＞［ Station ］
2．Press and hold the SET button of the wireless router “CRI-1” (separately sold).
3．The WiFi LED starts to flash green and then turns green.
※The [STA mode] icon will be displayed on the screen.
4．By connecting to a computer with “Image Mate 4 (TX-1 control software)” installed, you
can control the TX-1 from Image Mate 4.
※When using a third party’s wireless router, refer to the instruction manual of the router for
details of the connection procedure.
To Next Page
Loading...
