Chapter 3 53
4. Remove the mylar tape from the cable.
5. Disconnect the two antenna cables from the WLAN board, then move the antennas away from the board.
6. Remove the two screws (C) on the WLAN board to release the WLAN board.
7. Detach the WLAN board from the WLAN socket.
NOTE: When attaching the antennas back to the WLAN board, make sure the cable are routed properly.
Step Size (Quantity) Color Torque
1~2 M2 x L3 (2) Silver 1.6 kgf-cm
To Next Page
Loading...
