E-ESD3000-E-Manual.doc 37/66
8 What must be done following failed operation
• The ESD3000 has many of different messages to assist the operator to solve possible problems, give
information regarding incorrect operation of the ESD3000, or to correct an incorrect system
configuration.
8.1 Display messages
8.1.1 Examples of messages
The following message will occur when after three releases no discharges was happen
Information display
AD = air discharge,
CD = contact discharge
check whether the correct tip is
put on the DM, AD = air discharge,
CD = contact discharge
Message display
advice for changing mode
8.2 Service; Repairs
The ESD3000 is a compact equipment and servicing or repairing the generator can only be carried out by
EMC PARTNER authorised service companies.
Do not continue to use the instrument should any mechanical damage occur. The instrument housing has
both an insulating and a screening function which can only be assured when the housing is intact. Return a
damaged generator to EMC PARTNER service centre immediately for repair.
8.3 Spare parts list
No spare parts are necessary for the ESD3000.
To Next Page
Loading...
