E-ESD3000-E-Manual.doc 39/66
9 Charging the batteries or replacing batteries
The ESD3000 is a laboratory test equipment. Whenever the tester is not used, store it in the ESD3000 box.
The time the ESD3000 is not in use the batteries can be charge as follow.
connector to the ESD3000 on
the bottom side. The power
supply cord must be
connected to a public outlet
with voltage 110 V up to 240
V 50/60 Hz
The standard batteries can be changed as follow:
Unscrew the little screw on
the bottom of the ESD3000
and pull the battery back out
of the ESD3000
Charging time is approximately 5 hours (completely empty to completely full).
To Next Page
Loading...
