EMC-PARTNER ESD3000 - Page 4

ESD3000-System
4/66
3.2.3 Avoiding Mechanical Damage to Discharge Modules 18
4 CONTROL PANEL 19
4.1 Front panel of the ESD3000 19
4.2 Interchange of discharge modules 20
4.3 Interchange of the finger and tips 20
4.4 Inputs and Outputs 20
5 PREPARATION FOR OPERATION 21
5.1 Attention, Refer to Manual 21
5.1.1 ESD test set up 21
5.1.2 Test set-up for table top equipment 22
5.2 Practical testing sequence 23
6 TESTING WITH THE ESD3000 25
6.1 Contact discharge 25
6.2 Air discharge 26
6.3 Main parameter setting with the buttons on the front plate 27
6.4 The different software menus of the ESD3000 29
6.4.1 Repetition, number of pulses, count mode 29
6.4.2 Menu „Ramps“ 30
6.4.3 Menu „Setup“ 31
6.4.4 Menu „Settings“ 32
6.4.5 Menu „Service“ 32
6.4.6 Reset of the ESD3000 to default values 33
6.5 Parameter changing during operation „RUN Mode“ 33
7 MAINTENANCE AND SERVICING 35
7.1 Maintenance 35
7.2 Verification of the ESD3000 by the user 35
7.3 Verification of the ESD3000 by EMC PARTNER AG 35
7.4 System Reset 36
7.5 Caution with calibration labels 36
7.6 What must be done when the serial number is not indicated during the start up 36