a. Place the cover on the pump casing.
See Figure 10-9.
Replacing the Pump CoverFigure 10-9:
b. Be sure the pins at the bottom of the cover (Figure 10-10) ride on the tracks in the
pump casing.
PinsFigure 10-10:
c. The position of the track is outlined in Figure 10-11. The pins on the pump cover
must ride in these tracks as the cover is pushed into place. Gently squeeze the
ends of the cover to guide the pins.
TrackFigure 10-11:
d. Push down until the cover snaps into place.
Maintenance
Instruction Manual 79
To Next Page
Loading...
