Enclustra Mercury+ XU8 - Voltage Supply Inputs; Voltage Supply Outputs; VCC_IO Pins

Warning!
Do not apply any other voltages to the PWR_EN pin than 3.3 V or GND, as this may damage the Mer-
cury+ XU8 SoC module. PWR_EN pin can be left unconnected.
Do not power the VCC_IO pins (for example by connecting VCC_3V3 to VCC_IO directly) if PWR_EN is
used to disable the module. In this case, VCC_IO needs to be switched off in the manner indicated in
Figure 10.
2.11.3 Voltage Supply Inputs
Table 16 describes the power supply inputs on the Mercury+ XU8 SoC module. The VCC voltages used as
supplies for the I/O banks are described in Section 2.9.5.
Pin Name Module Connector Pins Voltage Description
VCC_MOD A-1, 2, 3, 4, 5, 6, 7, 8, 9, 11 5 - 15 V ±5% Supply for the 0.72/0.85/0.9 V, 0.85/0.9 V, 0.9
V, 1.2 V, 1.8 V, 3.3 V and 5.0 V voltage regula-
tors. The 2.5 V supply is generated from the
3.3 V supply. The input current is rated at 3 A
(0.3 A per connector pin).
VCC_BAT A-168 2.7 - 3.6 V Battery voltage for MPSoC battery-backed
RAM and battery-backed RTC
Table 16: Voltage Supply Inputs
2.11.4 Voltage Supply Outputs
Table 17 presents the supply voltages generated on the Mercury+ XU8 SoC module, that are available on
the module connector.
Pin Name Module Connector Pins Voltage Maximum Comment
Current
8
VCC_3V3
A-26, 29, 50, 86
3.3 V ±5%
4 A
Always active
B-55, 79, 115, 127, 152, 155 (and max 0.3 A
C-96, 103, 136, 143 per pin)
VCC_2V5 A-53, 62, 65, 89 2.5 V ±5% 0.25 A Controlled by PWR_EN
9
VCC_1V8
B-52, 76, 108, 128
1.8 V ±5% 1.5 A Controlled by PWR_EN
C-83, 123, 165
Table 17: Voltage Supply Outputs
9
8
The maximum available output current depends on your design. See sections 2.11.1 and 2.11.5 for details.
9
Please note that on modules revision 1.1 the 2.5 V supply is not powered off by the PWR_EN signal. If this voltage is used to supply
VCC_IO pins, power sequencing on the base board is required.
D-0000-454-001 29 / 60 Version 06, 18.11.2019