Endress+Hauser Ecograph RSG35 - Page 124

Appendix Ecograph T, RSG35
124 Endress+Hauser
Factory setting 8000
OPC port
Navigation Expert → Communication → Ethernet → OPC port
Direct access code: 150010-000
Description Values van be read via OPC server using this communication port.
If your network is protected by a firewall, this port may have to be enabled. Please
contact your network administrator if this is the case.
User entry Number (max. 5 digits)
Factory setting 8002
Web server
Navigation Expert → Communication → Ethernet → Web server
Direct access code: 470000-000
Description Switch the Web server functionality on/off. The instantaneous values can only be
displayed using an Internet browser when the web browser is activated.
A connection to the Web server can only be established via the Ethernet interface.
Options No (Web server is off), Yes (Web server is active)
Factory setting Yes
"Configuration Web server" submenu
Navigation Expert → Communication → Ethernet → Configuration Web server
Description Configure the Web server or specify which functionality should be possible via Web server.
Only visible if Web server = yes.
Instantaneous value display is always possible once the Web server is switched on.
Port
Navigation Expert → Communication → Ethernet → Configuration Web server → Port
Direct access code: 470003-000