Operating menu and parameter description iTEMP TMT82
90 Endress+Hauser
Configuration counter
Navigation Diagnostics → Device info. → Configuration counter
Expert → Diagnostics → Device info. → Configuration counter
Description Use this function to display the counter reading for changes to device parameters.
Static parameters, whose values change during optimization or configuration, cause
this parameter to increment by 1. This support parameter version management. If
several parameters change, e. g. due to loading of parameters from FieldCare, etc. in
the device, the counter can show a higher value. The counter cannot be reset and is
also not reset to the default value when the device is reset. If the counter overflows,
(16 bit), it starts again at 1.
13.2.4 "Measured values" submenu
Sensor n value
n = Stands for the number of sensor inputs (1 and 2)
Navigation Diagnostics → Measured values → Sensor n value
Expert → Diagnostics → Measured values → Sensor n value
Description Use this function to display the current measured value at the sensor input.
Device temperature
Navigation Diagnostics → Measured values → Device temperature
Expert → Diagnostics → Measured values → Device temperature
Description Use this function to display the current electronics temperature.
"Min/max values" submenu
Sensor n min value
n = Stands for the number of sensor inputs (1 and 2)
Navigation Diagnostics → Measured values → Min/max values → Sensor n min value
Expert → Diagnostics → Measured values → Min/max values → Sensor n min value
Description Use this function to display the minimum temperature measured in the past at sensor
input 1 or 2 (peakhold indicator).
To Next Page
Loading...
