Endress+Hauser Levelflex FMP54 - Page 187

Levelflex FMP51, FMP52, FMP54 FOUNDATION Fieldbus Operating menu
Endress+Hauser 187
"Automatic DC calculation" wizard
The Automatic DC calculation wizard is only available when operating via the local
display. When operating via an operating tool, all parameters concerning the
automatic DC calculation are located directly in the Interface submenu (→  182)
In the Automatic DC calculation wizard two parameters are displayed simultaneously
on the display module at any one time. The upper parameter can be edited, whereas
the lower parameter is displayed for reference purposes only.
Navigation  Setup → Advanced setup → Interface → Autom. DC calc.
Manual thickness upper layer 
Navigation  Setup → Advanced setup → Interface → Autom. DC calc. → Man.thick.up.lay
Description →  184
DC value 
Navigation  Setup → Advanced setup → Interface → Autom. DC calc. → DC value
Description →  185
Use calculated DC value 
Navigation  Setup → Advanced setup → Interface → Autom. DC calc. → Use calc. DC
Description →  186