General settings Liquistation CSF48
10
Overflow warnings
Logbook program="Fill up
buffer"
Options
•Off
•On
Factory setting
Off
If the fill-up buffer overruns, you can decide whether
you want to receive a diagnostic message from the cont-
roller or not for each individual logbook.
Data logbooks
New You can create a maximum of 8 data logbooks.
Logbook name Customized text,
20 characters
Source of data Options
•None
• Binary input 1
• Binary input 2
• Analog input 1
• Analog input 2
• Temperature
Factory setting
None
Select the input that should be the data source of the
logbook entries.
Measured value Options
• Depends on Source of
data
Factory setting
None
You can record different measured values depending on
the source of data.
Scan time 00:00:01 to 01:00:00
Factory setting
00:01:00
Minimum interval between two entries
Format: HH:MM:SS
Data logbook Options
•Off
• Ring buffer
• Fill up buffer
Factory setting
Off
Ring buffer
If the memory is full, the latest entry automatically
overwrites the oldest entry.
Fill up buffer
If the memory is 80% full, the device displays a diag-
nostic message.
If the memory is full, there is an overflow, i.e. no new
values can be saved. The controller displays a
corresponding diagnostic message. The memory then
has to be cleared manually.
Overflow warning
Data logbook="Fill up
buffer"
Options
•Off
•On
Factory setting
Off
If the fill-up buffer overruns, you can decide whether
you want to receive a diagnostic message from the cont-
roller or not for each individual logbook.
Add another logbook Action Only if you want to create another data logbook
immediately.
You add a new data logbook at a later data using New.
Finished Action This allows you to exit the menu New.
Path: Menu/Setup/General settings/Logbooks
Function Options Info
To Next Page
Loading...
