General settings Liquistation CSF48
8
2.3 Automatic hold (optional)
If a device-specific hold is enabled, any cleaning that was previously started is stopped. You
can only start a manual cleaning if a hold is active.
Path: Menu/Setup/General settings/Automatic hold
Function Options Info
Device specific hold
Setup menu Options
• Disabled
•Enabled
Factory setting
Disabled
Decide whether a hold should be output at the current
output when the particular menu is opened.
Diagnostics menu
Calibration active Factory setting
Enabled
Hold release time 0 to 600 s
Factory setting
0 s
The hold is maintained for the duration of the delay
time when you switch to the measuring mode.
To Next Page
Loading...
