Liquistation CSF48 Inputs: ISE
167
17 Inputs: ISE
17.1 Basic settings
17.1.1 Sensor identification
17.1.2 Main value
The main value can be any parameter which is returned by one of the electrodes in the
ISE-sensor.
17.1.3 Damping of the temperature value
The damping causes a floating average curve of the measured values over the time specified.
Path: Menu/Setup/Inputs/<Sensor type>
Function Options Info
Channel Options
•On
•Off
Factory setting
On
On
The channel display is switched on in the measuring
mode
Off
The channel is not displayed in the measuring mode,
regardless of whether a sensor is connected or not.
Sensor type Read only
(Only available if a sensor is
connected)
Connected sensor type
Order code Order code of the connected sensor
Path: Menu/Setup/Inputs/ISE
Function Options Info
Main value Options
• Ammonium
•Nitrate
•Potassium
•Chloride
•pH
•ORP
Factory setting
pH
Decide which parameter you want to display as the main
value for the ISE channel.
Here, you can only choose from the electrodes which you
configured via the electrode slot menus.
At the factory, this is equivalent to the types of electrode
that are actually installed in the ISE sensor.
Path: Menu/Setup/Inputs/ISE
Function Options Info
Damping temp. 0 to 300 s
Factory setting
0 s
Specify the damping for the temperature measurement.
To Next Page
Loading...
