Endress+Hauser Liquistation CSF48 - Tag Control; Sensor Replacement; Data Processing Factory Setting; Sensor Factory Setting

Liquistation CSF48 Inputs: SAC
161
Process check system
--> "Inputs: General/Frequently occurring functions" section  ä 108
Sensor operating hours
The data displayed here are the current hours the device has been in operation under extreme
conditions. You cannot make any changes. You can only read the values.
The same data can be found in the Diagnostics menu.
Diagnostic behavior
--> "Inputs: General/Frequently occurring functions" section  ä 108
15.2.5 Tag control
--> "Inputs: General/Frequently occurring functions" section  ä 108
15.2.6 Sensor replacement
--> "Inputs: General/Frequently occurring functions" section  ä 108
15.2.7 Data processing factory setting
--> "Inputs: General/Frequently occurring functions" section  ä 108
15.2.8 Sensor factory setting
--> "Inputs: General/Frequently occurring functions" section  ä 108
Lamp life
Warning limit Factory setting
35040 h
Diagnostics code and associated message text:
171 "Lamp change"
Alarm limit Factory setting
36500 h
Diagnostics code and associated message text:
71 "Lamp change"
Path: Menu/Setup/Inputs/SAC/Extended setup/Diagnostics settings
Function Options Info