Inputs: General Liquistation CSF48
114
9.2.9 Sensor replacement
When the sensor is replaced, the last measured value is retained via the "hold" function. A diag-
nostics message is not triggered.
9.2.10 Data processing factory setting
Here you can restore the factory settings for the sensor input. For this purpose, simply press the
navigator button and select "OK" when the prompt for the device software appears.
Only the factory settings for this particular input are restored. All other settings remain
unchanged.
9.2.11 Sensor factory setting
Here you can restore the sensor factory settings. For this purpose, simply press the navigator
button and select "OK" when the prompt for the device software appears.
Only the factory settings for the sensor are restored. The settings for the input remain
unchanged.
To Next Page
Loading...
