Operation Liquistation CSF48
106 Endress+Hauser
Multiple bottles 0 to 23
The configuration options
depend on the current number
of bottles
Factory setting
0
Multiple bottles:
"Simultaneous" transfer of two samples to separate
bottles.
Start condition Options
•Immediate
•Date/time
Factory setting
Immediate
The sampling program can be started either
immediately or at a specific, configurable time.
If Start condition Immediate is selected:
Sample at start Options
•Yes
•No
Factory setting
Yes
Yes:
The first sample is taken when the program is started.
No:
The system waits for the interval to elapse before the
first sample is taken.
If Start condition Date/time is selected:
Start date 01.01.2000 to 31.12.2099
Factory setting
DD.MM.YYYY
Set the start date for the sampling program. The
format depends on the option configured under
general settings.
Start time 00:00:00 to 23:59:59
Factory setting
HH:MM:SS (24h)
Set the time when the sampling program is started.
The format depends on the option configured under
general settings.
Stop condition Options
•Program end
• Continuous
Factory setting
Program end
Program end:
The device stops sampling automatically once it has
run through the set program.
Continuous:
The device runs through the set program continuously
in an infinite loop. Do not forget to empty the bottles.
The bottle level is reset once a program loop has been
run through.
Assignment bin. output Options
• No binary output configured
• Binary output S:x
Factory setting
No binary output configured
Assignment of the binary output to the program cycle.
Inputs Settings for the inputs can be made as described in the
"Inputs" section.
Path: Menu/Setup/Sampling programs/Setup program/New/Basic
Function Options Info
To Next Page
Loading...
