Endress+Hauser Liquistation CSF48 - Page 122

Operation Liquistation CSF48
122 Endress+Hauser
If Start condition Volume is selected:
Start volume input Options
• No flow input configured
• Binary input S:x
• Current input S:x
Factory setting
No flow input configured
Select the start volume input.
The binary input or the current input must be
configured for this function.
Only the inputs configured for flow measurement are
displayed.
Start flow sum 1.000 to 9999.000 m³
Factory setting
10,000 m³
Set the start volume.
Stop condition Options
•Program end
• Continuous
•Date/time
Factory setting
Program end
Program end:
The device stops sampling automatically once it has
run through the set program. All the assigned bottles
are filled.
Continuous:
The device runs through the set program
continuously in an infinite loop. Do not forget to
empty the bottles.
Date/time:
The device stops the set program at a specific time.
If Stop condition Date/time is selected:
Stop date 01.01.2000 to 31.12.2099
Factory setting
DD.MM.YYYY
Set the stop date for the sampling program. The
format depends on the option configured under
general settings.
Stop time 00:00:00 to 23:59:59
Factory setting
HH:MM:SS (24h)
Set the time when the sampling program is stopped.
The format depends on the option configured under
general settings.
Setup subprogram
New
Programpart Use a distinct name for your subprogram. The
program name can be up to 16 characters long.
Path: Menu/Setup/Sampling programs
Function Options Info