How to fix incorrect current value on the current output of my Endress+Hauser Liquistation CSF48 Laboratory Equipment?
If the current output shows an incorrect current value, it might be due to incorrect adjustment. Check with integrated current simulation and connect an mA meter directly to the current output.
Why is my sample not representative with my Endress+Hauser Liquistation CSF48 Laboratory Equipment?
If your sample isn't representative, it could be due to a siphon in the sampling hose, so check the sampling hose. Another cause might be a connection that isn't airtight or a sampling hose taking in air; check the tubes and connections, and ensure the sampling hose is routed correctly. The wrong pump tube could be the cause, use only a genuine pump tube.
What to do if values appear on display but the display does not change and/or device cannot be operated on my Endress+Hauser Liquistation CSF48 Laboratory Equipment?
If values appear on the display but the display doesn't change or the device cannot be operated, the module may not be wired correctly, check the modules and wiring. It could also be due to an impermissible operating system condition; try switching the device off and then on again.
Why is my Endress+Hauser Laboratory Equipment not sampling?
If your device isn't sampling, it could be due to a connection leak, so check the tubes and connections for leaks. It may also be that the sampling hose is taking in air; ensure the sampling hose is routed correctly. If these steps don't resolve the issue, the wrong pump tube could be the cause, use only a genuine pump tube.
What to do if control signals are not accepted or outputs do not switch on my Endress+Hauser Liquistation CSF48 Laboratory Equipment?
If control signals aren't accepted or outputs don't switch, the issue could stem from an incorrect program setting, so you should check the program setting. Incorrect wiring could also be the cause, so verify the wiring. In some cases, it may be due to electronics failure, and you may need to replace the basic module.
General| Power supply | 100 to 240 VAC, 24 VDC |
|---|---|
| Cooling | Integrated cooling system |
| Housing material | Stainless steel |
| Communication | Ethernet |
| Protection | IP65 |
| Process Temperature Range | 0°C to 40°C |
| Protection Class | IP65 |
| Material | Stainless steel |
| Certification | CE |
To Next Page
