Endress+Hauser Proline Prosonic Flow 93T Portable - Page 34

Operation Proline Prosonic Flow 93T Portable
34 Endress+Hauser
Display (operating mode)
The display area consists of three lines in all; this is where measured values are displayed, and/or
status variables (direction of flow, bar graph, etc.). You can change the assignment of display lines
to different variables to suit your needs and preferences.
Multiplex mode:
A maximum of two different display variables can be assigned to each line. Variables multiplexed in
this way alternate every 10 seconds on the display.
Error messages:
In-depth information on how system/process errors are displayed is provided on  ä 51 ff.
A0001173
Fig. 38: Typical display for standard operating mode (HOME position)
1 Main line: shows main measured values, e.g. volume flow in [l/s].
2 Additional line: shows additional measured variables and status variables, e.g. totalizer reading No. 3 in [m3].
3 Information line: shows additional information on the measured variables and status variables, e.g. bar graph
display of the end value achieved by the volume flow.
4 "Info icons" field: icons representing additional information on the measured values are shown in this field.
A full overview of all the symbols and their meaning is provided on  ä 35.
5 "Measured values" field: the current measured values appear in this field.
6 "Unit of measure" field: the units of measure and time defined for the current measured values appear in this field.
!
Note!
From the HOME position, you can use the OS keys to open an "Info Menu" containing the
following information:
• Totalizers (including overflow)
• Actual values or states of the configured inputs/outputs
• Device TAG number (user-definable).
OS key  Scan of individual values within the list
Esc key (X)  Return to HOME position
1
45
6
2
3
+24.502
+1863.97
x
x
y
y
–50
+50
%
v
v
3
S