Proline Prosonic Flow 93T Portable Operation
Endress+Hauser 39
5.4.3 Confirming error messages
For plant and process safety reasons, the measuring device can be configured in such a way that
fault messages displayed ($) not only have to be eliminated but also have to be confirmed by pressing
F. Only then will error messages disappear from the display!
This function is enabled or disabled via the ACKNOWL. FAULTS function.
!
Note!
• Fault messages ($) can also be reset and confirmed via the status input.
• Notice messages (!) do not have to be confirmed. However, they remain on the display until the
cause for the error has been eliminated.
5.5 Communication
5.5.1 FieldCare
FieldCare is Endress+Hauser’s FDT-based plant asset management tool and allows the configuration
and diagnosis of intelligent field devices. By using status information, you also have a simple but
effective tool for monitoring devices. The Proline flowmeters are accessed via a service interface or
via the service interface FXA193.
To Next Page
Loading...
