Proline Prosonic Flow 93T Portable Identification
Endress+Hauser 9
2.2 Certificates and approvals
The devices are designed in accordance with good engineering practice to meet state-of-the-art
safety requirements, have been tested, and left the factory in a condition in which they are safe to
operate.
The devices comply with the applicable standards and regulations in accordance with EN 61010-1
"Safety requirements for electrical equipment for measurement, control and laboratory use" and
with the EMC requirements of IEC/EN 61326.
The measuring system described in these Operating Instructions thus complies with the statutory
requirements of the EC Directives. Endress+Hauser confirms successful testing of the device by
affixing to it the CE mark.
The measuring system complies with the EMC requirements of the "Australian Communications
and Media Authority (ACMA)".
2.3 Registered trademarks
HART
®
Registered trademark of HART Communication Foundation, Austin, USA.
FieldCare
®
, Applicator
®
Registered or registration-pending trademarks of Endress+Hauser Flowtec AG, Reinach, CH.
To Next Page
Loading...
Need help?
General
