Endress+Hauser Proline Prowirl 72 - Page 102

11 Operation via FOUNDATION Fieldbus Proline Prowirl 72 FOUNDATION Fieldbus
102 Endress + Hauser
Simulation -
Measurand
Value
AUTO - OOS
! Note!
This function is not effective unless the "Simulation - Measurand"
function is active.
Use this function to specify a selectable value (e.g. 12 dm³/s). This is
used to check the assigned parameters in the device itself and
downstream signal circuits.
User input:
5-digit floating-point number
Factory setting:
0
! Note!
The unit is taken from the "Simulation - Unit" parameter
(Page 102).
" Caution!
The setting is not saved if the power supply fails.
Simulation - Unit Read only The current unit for the simulation value in the "Simulation - Measurand
Value" parameter appears on the display.
! Note!
Depending on the option selected in the "Simulation – Measurand"
function (Page 101), the unit is determined by means of the "System
Unit – Volume Flow", "System Unit – Calc. Mass Flow" or "System Unit –
Corr. Volume Flow" parameter (Page 90, 91, 92).
Serial Number Read only The serial number of the sensor appears on the display.
Sensor - Type Read only Use this function to view the sensor type.
Sensor - Serial
Number 
DSC Sensor
Read only The serial number of the DSC sensor appears on the display.
Transducer Block "Flow" (Endress+Hauser parameters) / base index 500
Parameter Write access for
operating mode
(MODE_BLK)
Description