EnerCharge ECC 320 - General Information; List of Abbreviations

6
Manual: Transport, Installation and Start-Up: DC CompactCharger ECC 320 ©EnerCharge GmbH
GENERAL INFORMATION
2. General Information
After the foundation has been laid, the ECC
320 can be mechanically mounted, electrically
installed and put into operation. The installation
must be carried out by qualied personnel. See:
„3.2 Qualification of Staff“ on page 7.
The technical acceptance according to the
system book before the initial commissioning
must be carried out by a qualified electrical spe-
cialist company.
The ECC 320 is an electrotechnical device and
is therefore subject to certain specications for
installation indoors and outdoors: Although the
housing of the ECC 320 meets the IP44 protection
class specied by the standard, various environ-
mental conditions must be taken into account,
especially outdoors. More information on this can
be found in the technical data (9.2 on page 47).
For safe operation of the ECC 320, minimum di-
stances to other technical installations must be
taken into account: Your electrical installation
company or Sales Partner can provide further in-
formation.
The ECC 320 must be mounted so that it is freely
accessible to the persons authorized to operate it.
AC
A
DC
CCS/CCS Combo-2
LAN
LRM
NFC
OCPP
PVC
RFID
WAN
> Alternating current
> Ampere
> Direct current
> Combined Charging System
> Local Area Network
> Load regulation management (proprietary technology by EnerCharge to control
up to 40 external AC and DC charge points)
> Near Field Communication
> Open Charge Point Protocol - Communication standard for the communication
between the charging station and the vehicle.
> Polyvinylchlorid (thermoplastic polymer)
> Radio Frequency Identification (identifiction through electromagnetic waves)
> Wide Area Network (A computer network that, unlike LAN, extends over a very
large geographical area.)
2.1 List of Abbreviations