EnerCharge ECC 320 - Safety Notices; Important Safety Notices; Qualification of Staff

7
Manual: Transport, Installation and Start-Up: DC CompactCharger ECC 320 ©EnerCharge GmbH
SAFETY NOTICES
> Read this manual as well as the operating manual completely and carefully before initial start-up.
If you have any questions, contact the manufacturer.
> Keep the instructions in a way that they are at hand in case of need.
> The ECC 320 may only be installed on a suitable foundation as specied.
> Observe and follow the warnings and notes contained in this manual.
> Apply the 5 safety rules when handling the ECC 320.
> Any modication and/or addition to the ECC 320 is only permitted after consultation with the
manufacturer and only using parts authorized by the manufacturer.
> Unauthorized conversions and/or modications to the equipment will result in the immediate
loss of all warranty and guarantee claims.
> The equipment must be operated without exception within the specied operating temperature
range. See „9.2 Technical Data“ on page 47 for permissible temperature ranges.
> Do not install the ECC 320 in a potentially explosive environment (EX area) under any circum-
stances.
> The ECC 320 can develop a higher surface heat on hot days and with a large workload. Therefore,
pay attention to the surface temperature.
> The ECC 320 is protected against spray and splash water according to IP44. Do not install the ECC
320 in the immediate vicinity of running water or water jets.
> Never install the ECC 320 in areas subject to ooding.
> Personal protective equipment must be worn when working on the ECC 320:
Adapt your personal protective equipment to local regulations and conditions.
Important safety instructions for handling the ECC 320.
3. Safety Notices
3.1 Important Safety Notices
3.2 Qualification of Staff
The activities for installation and initialization/commissioning may only be carried out by
persons who have the necessary qualications. These include: Qualied electrician and
qualied personnel for installation and initialization/commissioning.
> Qualied Electrician: Based on their training, knowledge and experience, is able to
independently perform work on electrical components for installation, commissio-
ning and maintenance in a professional and safe manner. The electrician knows the
relevant standards and regulations.
> Specialized personnel for installation and commissioning: Based on their training,
knowledge and experience, they are able to carry out installation and commissioning
activities independently in a professional and safe manner.