Enterasys S-Series S4 Chassis Hardware Installation Guide 2-1
2
Installation Requirements and Guidelines
This chapter describes the following:
For information on environmental guidelines, including airflow considerations, refer to
Appendix C, Environmental Guidelines.
Site Guidelines
You must follow the guidelines listed below when selecting a site for the S4 chassis.
Location Guidelines
• You must install an S4 chassis, with or without a PoE subsystem, in a restricted access location.
This location should only be accessible by people who have been trained or are technically
competent enough to be aware of potential risks of accessing the hazardous areas of the
chassis. Locations such as a locked wiring closet or locked cabinet meet this requirement.
• You must install an S4 chassis that uses S-DC-PS power supplies in a restricted access location.
Rack Mounting Guidelines
• To install the S4 chassis as a freestanding unit on a shelving unit, the shelf must be able to
support 113.4 kilograms (250 pounds) of static weight.
• If you are mid-mounting the S4 chassis, you must bolt the rack to the floor or ensure that the
rack is supported in such a way that the mid-mounted S4 chassis does not create a tipping
hazard.
• To install the S4 chassis as a rack mounted unit, care must be taken to ensure that the rack
used will support the unit and that the rack remains stable.
For more information about: Refer to page...
Site Guidelines 2-1
Precautions 2-2
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und qualifiziertes
Personal vorgenommen werden.
To Next Page
Loading...
Need help?
General
