Completing the Installation
3-34 Chassis Setup
Completing the Installation
After installing the S4 chassis and making the connections to the network, access the device
management startup screen from your PC or terminal connection as described in this section.
Start the Command Line Interface (CLI) from the device’s local console port as follows:
1. Connect a terminal to the local console port as described in “Connecting to the COM Port for
Local Management” on page 3-31. The startup screen displays.
2. At the login prompt, enter one of the following default user names:
– ro for Read-Only access
– rw for Read-Write access
– admin for Super User access. (This access level allows Read-Write access to all modifiable
parameters, including user accounts.)
3. Press Enter.
4. The Password prompt displays. Leave this string blank and press Enter. The device
information and S Chassis prompt displays as shown in Figure 1.
The S4 chassis is now ready to be configured. For information about setting the IP address and
configuring Telnet settings for remote access to S4 chassis management, refer to the Enterasys
S-Series Configuration Guide.
The CLI commands enable you to initially set up and perform more involved management
configurations. The Enterasys S-Series Configuration Guide is available online at:
https://extranet.enterasys.com/downloads/
Note: This procedure applies only to initial log-in and to logging in to a device not yet configured
with administratively-supplied user and password settings.
By default, the S4 chassis is configured with three user login accounts: ro for Read-Only access; rw
for Read-Write access; and admin for super-user access to all modifiable parameters. The default
password is set to blank (carriage return). For information on changing these default passwords,
refer to the
Enterasys S-Series Configuration Guide.
login: admin
Password:
S4
Command Line Interface
Enterasys Networks, Inc.
50 Minuteman Rd.
Andover, MA 01810-1008 U.S.A.
Phone: +1 978 684 1000
E-mail: support@enterasys.com
WWW: http://www.enterasys.com
(c) Copyright Enterasys Networks, Inc. 2009
Chassis Serial Number: xxxxxxxxxxxx
Chassis Firmware Revision: xx.xx.xx
S Chassis(su)->
To Next Page
Loading...
Need help?
General
