14
safety scReen
The safety screen is attached by two hooks on the top edge of the unit (see Figure 12). Lift top plate to gain
safety screen lift clearnace (see instruction previous page); gently and carefully lift the screen up and away
from the unit (see Figure 13).
*NOTE: The screen uses rubber bumpers as a cushion between it and the main body of the fireplace to
prevent damage to the exterior. Even with these in place, it is important to be very careful when removing/
attaching the safety screen as to not scratch or chip the paint.
Screen
Attachment
Hooks
Figure 12: Safety Screen Attachment Hooks
(Top Plate Removed for Visability)
Figure 13: Safety Screen Removal
Maintenance And Service
Safety Screen Positioning: The two upper side hooks mount over the door drame. The center bumper
rests on the OUTSIDE of the door frame (see Figure 14 for clarification). The lower three standoff bumpers
also rest against the outer surface. Take care not to scratch any painted surfaces.
Attachment Hook
(Inside Unit)
Stando
(On Outer Face)
Figure 14: Safety Screen Attachment (Top-Down View)
To Next Page
Loading...
