52
Secondary Installation
Log set instaLLation
STEP 1: Place burner media on burner. Use either vermiculite
or ember wool; if using ember wool, tear it apart into fine
thin strands with your fingers - wear gloves. Do not cover up
meshed air ports or burner air slots, these must remain clear.
STEP 2: Place Log 1 and into position as shown. Log 2 will sup-
port Log 1 in a distinctive area. Each log should be contacting
side and rear liners and spaced off burner air slots by 1/4”
(6mm). See Figure 92.
STEP 3: Place the divot underneath Log 3 over the rear
base screw head. Pivot the log slightly counterclockwise.
Place shale and/or vermiculite on either side on the log as
desired. See Figure 93.
STEP 4: Place the divot underneath Log 4 over the front base
screw head. The orientation will need to be adjusted during
the next step. See Figure 94.
STEP 5: The backside of Log 5 should be parallel to the burner
but spaced off the air slot by 1/4” (6mm). Rotate Log 4 until
the tip of Log 5 slots into the nook. See Figure 95.
Figure 92: Step 2 - Log 1 & 2
Figure 93: Step 3 - Log 3
Figure 94: Step 4 - Log 4
Figure 95: Step 5 - Log 5
Prior to setting up the log set, remove the door frame and glass from the unit. Refer to their respective
sections on page 15 and page 16 for detailed instructions.
Figure 99: Log 7 Placement (Top View)
To Next Page
Loading...
