54
Secondary Installation
meDia instaLLation
No media in hatched areas
Media placed in shaded areas
To install media into your unit, perform the following steps:
1. Remove the door frame (refer to section remoVing the Door Frame/Skirt on page 15).
2. Remove the glass (refer to section remoVing the glaSS on page 16).
3. Place your burner media into the burner platform creating a thin layer that evenly covers the entire
burner pan; pat it down gently.
*Note: Ensure that the areas highlighted in Figure 101 are not covered by media. These areas must be
clear to allow the proper flow of air. Failure to do so will cause the fireplace to not burn properly.
4. Reinstall the glass and door frame.
Figure 100: Proper Log Setup/Burn
Figure 101: Media Installation Area
To Next Page
Loading...
