19
RePLacing tRim PaRts
Maintenance And Service
When replacing the fan, ensure the label-side is facing down and electrical contacts are positioned at the same
corner as retainer #1 (see Figure 27). Re-attach the electrical harness and work fan into position by wedg-
ing the respective corner into retainer #2 (see Figure 27). Try not slidng the fan on the foam gasket, it’s for
compression only. Once in place, position retainer #1 back over the respective corner and hold in place while
reattaching retainer screw; the fan should now feel secure. Reconnect power and test fan.
Retainer #2
(Attached to unit)
Retainer #1
Figure 27: Fan Removal (Top-Down View)
All powder coated trim pieces on the S50 can be removed and replaced if damaged. This section will go over
how to remove these pieces from the unit to then be replaced.
DooR hooks
Figure 28: Door Frame Hook Removal
First, remove the door frame from the unit (refer to the
remoVing the Door Frame/Skirt section on page 15).
The door frame hooks are each attached to five (5)
studs on the main door frame. Remove the nuts retain-
ing the hooks and remove from the door frame (refer
to Figure 28).
To Next Page
Loading...
