42
Initial Installation
QUALIFIED INSTALLERS ONLY
eLectRicaL RequiRements
toP PLate coLLaR instaLLation
The top plate collar is an aesthetic band that helps hide the venting connection for top vent applications.
Prior to installing the venting, place the collar on top of the unit around the vent adaptor (see Figure 61).
The collar does not fasten to the unit but is heavy enough to sit in place securely.
Electrical
Connection
Gas
Connection
WARNING: This appliance is equipped with a three-prong
(grounding) plug for your protection against shock hazard and
should be plugged directly into a properly grounded three-
prong receptacle. Do not cut or remove the grounding prong
from this plug.
The appliance, when installed, must be electrically
grounded in accordance with local codes or, in the ab-
sence of local codes, with the National Electrical Code,
ANSI/NFPA 70, or the Canadian Electrical Code, CAN/
CSA C22�1�
The S50 does not require power to operate the flame. Howev-
er, a 120V 15A circuit is required to operate included top light
and convection fan (optional).
All electrical connections for the S50 are done internally and
come pre-wired directly from the factory. Connect the supplied
IEC power cord into the receptacle at the back of the unit (see
Figure 60) and into a wall outlet.
The electrical and/or gas connection can alternatively to recon-
figured to come up through the pedestal for a cleaner look.
An internal wiring diagram of the electrical components can be
found at the back of this manual on page 58.
Figure 60: Electrical and Gas Connections
Figure 61: Top Plate Collar Placement
To Next Page
Loading...
