Enviro S50 - Fuel Conversion Procedure Overview

23
Maintenance And Service
Figure 35: Pilot Fence Removal
Figure 36: Burner Removal
fueL conveRsion
TO BE INSTALLED BY A QUALIFIED SERVICE AGENCY ONLY
Please read and understand these instructions before installing.
Warning: This conversion kit shall be installed by a qualied service agency in accordance
with the manufacturer’s instructions and all applicable codes and requirements of the
authority having jurisdiction. If the information in these instructions is not followed
exactly, a re, explosion or production of carbon monoxide may result causing property
damage, personal injury or loss of life. The qualied service agency is responsible for
the proper installation of this kit. The installation is not proper or complete until the
operation of the converted appliance is checked as specied in the manufacturer’s
instructions supplied with the kit.
Kit Parts List for all S50 models:
1 - Orice (NG: #37) or (LP: #53)
1 - Pilot Orice (LP orice supplied with unit)
1 - Conversion label
1 - Installation instruction sheet
Carefully inspect all parts supplied with this conversion kit. If any parts have been damaged or are missing,
contact your dealer, distributor or courier company to have them replaced before starting this installation.
Conversion Kit Installation:
1. Turn control knob on the gas valve to the “OFF” position and shut the gas supply o at the shut-o valve
upstream of the unit. CAUTION: The gas supply must be shut o prior to disconnecting the electrical
power and before proceeding with the conversion. Allow the valve and unit to cool down to room
temperature.