22
Detaching the tension cabLe
The top plate support system uses a tensioned safety cable to establish hinge stability. Should the top plate
need to be removed, disconnect the cable retainer by removing the two T20 screws (see Figure 33).
WARNING: Always ensure tensioned safety cable is attached to the top plate.
Maintenance And Service
Figure 33: Top Plate Cable Detachment
buRneR RemovaL
The stainless steel burner pan will need to be
checked seasonally for corrosion and foreign
debris. Ensure no material is obstructing the
segregated pilot area or air servicing channels
as illustrated in Figure 99. Remove the burner
for inspection.
To remove the burner, first remove the door
frame and glass (refer to page 15 and page
16 for details). Remove the nine (9) screws
securing the burner platform using a T20 screw-
driver (see Figure 34).
Remove the pilot fence by hand taking care not
to damage the ceramic fiber gasket (see Figure
35). This gasket is used to prevent drafts from
interfering with the pilot flame so replace if
damaged.
Remove the four (4) screws securing the burner
pan using a T20 screwdriver. Rotate the burner
upward and lift out (see Figure 36).
Figure 34: Burner Platform Removal
To Next Page
Loading...
